Tighten the wheel hub mounting bolts to 130 N.Install the wheel hub mounting bolts (fig. Properly position the wheel bearing to assure the wheel speed sensor connector and cable are located property to attach to the retaining clip. Route the wheel speed sensor connector and cable through the knuckle and position the wheel hub into the knuckle.Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems. These coatings affect fastener torque and joint clamping force and may damage the fastener. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the proper service procedure. Replacement fasteners must be the correct part number for that application. Use the correct fastener in the correct location.Install the wheel hub and bearing assembly to the suspension knuckle. The Front and Rear Wheel Hub/Wheel Speed Sensor are both splined holes through the center of the bearing. The Front and Rear Wheel Hub/Wheel Speed Sensors are interchangeable.Remove the hub and bearing assembly from the suspension knuckle (fig.For rear wheel bearing replacement, remove the axle from bearing.Lift the suspension knuckle up from the lower control arm (fig.Separate the suspension knuckle from the lower control arm ball joint stud.Remove the lower ball joint retaining nut.For rear wheel bearing replacement, remove the spindle nut and the washer (fig.Disconnect the real-time damping (RTD) position sensor link, if equipped.Remove the brake caliper mounting bracket and the rotor (fig.Remove the brake caliper and brake pads from the caliper mounting bracket. Remove the brake caliper guide pin bolts.Disconnect the wheel speed sensor connector.Raise and properly support the vehicle.A person with moderate mechanical skills who is familiar with automotive components should only attempt the replacement of wheel bearings.

C6 wheels on a c5 corvette